9-5
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
072: Disable Preaccess Requirement for a Port
This command allows you to turn off preaccess as set with Commands 070 or 071. It sets the
specified port back to factory defaults:
• Force-execution digit is 'D'
• Autoexecution is off
• Preaccess is off
It also restores the preaccess macro for that port back to factory defaults:
• Empty (contents are deleted)
• DTMF execution mask cleared
<072> p
Parameters:
- 072 is the default command name.
- P is the port for which to turn the preaccess requirement off (1..2)
073: Recall Ports with Preaccess Requirement
This command allows you to determine which ports require preaccess.
<073>
Parameters:
- 073 is the default command name.
074: Allow Access To a Port that Requires Preaccess
This command allows commands to be executed on the port the command is executed from
until the preaccess timer which it starts (see command 020 for more info on timers) runs out. It
is usually called from the preaccess macro (see Chapter 8) for that port so that when that
preaccess macro is executed, it temporarily allows access to the rest of the commands in the
controller.
<074>
Parameters:
- 074 is the default command name.
To Next Page
Loading...
Need help?
General
