18-10
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
191: Assign a Callsign to a User
This command assigns a callsign to a user number. User 14 might be KC7HXB for example.
This callsign is used when the controller speaks messages about logging on and off and in
several other places. It is possible to use a different name for a user instead of their callsign.
The default "callsigns" are just the user number; user 14 is "zero one four". The "callsign" can
consist of any words listed in Appendix B. This includes all of the numbers and letters and the
special words like the current time.
<191> uuu Recall user callsign
<191> uuu www..www Set the user callsign
Parameters:
- 191 is the default command name
- UUU is the user number (000..500)
- www..www is a list of word numbers from Appendix B. There is a limit of 8 words
per user number.
To Next Page
Loading...
Need help?
General
