16-5
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
039: Recall the Ports in the Current Audio Routing Variable
This command allows you to determine what ports audio is being sent out of without having a
radio tuned to each of the transmitters. It speaks a list of numbers which represent the ports
that are included in the audio routing variable at the time it is executed (see Appendix A for
more information about audio routing variables). If it is executed directly, it will tell you what
port you are executing commands from..
<039>
Example:
You want to know what transmitters are hearing the courtesy beep that is generated
when port 2's receiver unkeys. Solution: append this command to the end of the courtesy beep
macro (233) for port 2 so it will speak the number of the ports that just heard the courtesy beep:
<056> 233 039 D or unkey or <Enter>
Note:
To delete command 039 from the courtesy beep macro when you are tired of hearing it,
use command 058 and you will not have to delete the whole macro and program it again.
To Next Page
Loading...
Need help?
General
