1-12
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Windows Programming
TM
The RLC-Club comes with a complete Windows programming software program. This
TM
software runs on PC compatible computers. An 80386 or 80486 computer is recommended for
running this software.
Installation:
Installation of the RLC-Club software requires a 3½" disk drive and a hard drive on your
computer. Install the 3½" disk in the drive. From 'File Manager' under Windows select the
TM
'A:' drive and execute the file 'Install.Exe'. The club software will auto-install itself on the hard
drive under the directory '\CLUB'. An icon will now appear that allows access to the 'Club'
software.
Operation:
Click on the 'Club' icon and the software will begin to run. Once the software is running
you must either load an existing file or select the 'File' option and start a new file. After a file is
open you can continue through the software setting up your controller.
Once your changes have been made save the file. You can either quit now or download
the software to a controller via. modem software or a direct connection (with a cable connected
between your computer and the controller).
Limitations:
Not all functions of the controller can be accessed from this software. We have tried to
include the most often used functions in this software to ease your interfacing of the RLC-Club.
Windows is a registered trademark of Microsoft Corporation.
TM
To Next Page
Loading...
Need help?
General
