14-2
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Using the RBI-1 or RLC-ICM:
Using the RBI-1 or RLC-ICM (after it is set up) is very straightforward. There are separate
commands to do each of the following tasks:
139: Setup RLC-Icom Interface
141: Set Band Unit for RBI-1 or RLC-ICM
142: Set Frequency and Optional Offset for RBI-1 or RLC-ICM
143: Set Offset for RBI-1 or RLC-ICM
144: Set Offset Format for RBI-1 or RLC-ICM
145: Set Power Level for RBI-1
146: Set PL Frequency for RBI-1 or RLC-ICM
147: Turn PL Encode Off/On for RBI-1 or RLC-ICM
148: Turn PL Decode Off/On for RBI-1 or RLC-ICM
149: Recall Band, Frequency and Offset for RBI-1 or RLC-ICM
150: Recall All RBI-1 or RLC-ICM Settings
151: Turn Radio Power On or Off for RBI-1
152: Goto Radio Memory for RBI-1
If there are combinations of settings that you use often, you can program them into the
memories on the Kenwood radios (if you are using the RBI-1) or you can program user macros
to select those settings, making the controller's macro work like a memory.
To Next Page
Loading...
Need help?
General
