2-6
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
003,004: Recall a Port's Connections
This command allows you to find out where port X's receiver or transmitter is connected.
<003> x Interrogate a Receiver
<004> x Interrogate a Transmitter
Parameters:
- 003 is the default command name. This command finds what transmitters are
connected to receiver 'X' is routed to.
- X is the receiver to recall the connections to
- 004 is the default command name. This command finds what receivers are routed to
transmitter 'X'
- X is the transmitter to recall the connections to
Default:
- Port 1 defaults as a repeater
- Port 2 defaults as a link
- Port 3 is the autopatch
Example 1:
Port 1 is connected to ports 2 3
<003> 1 D or unkey or <Enter>
Response:
Voice Response "1 Connect 2 3"
Example 2:
Ports 1,2 are connected to port 3
<004> 3 D or unkey or <Enter>
Response:
Voice response "3 Connect 1 2"
To Next Page
Loading...
Need help?
General
