11-4
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
085: Enable/Disable IDing a Port
This command allows you to enable or disable the IDing functions for a port. Normally all
ports are IDed, including link ports. Often this is not desired. This command allows you to
turn off the IDing functions.
<085> p c
Parameters:
- 085 is the default command name.
- P is the port for which to enable or disable the ID's (1..3)
- C is 1 to enable ID's, 0 to disable them
Defaults:
All ID's are enabled
Notes:
If you only want to disable some of the ID's for a port, keeping the pending ID's but not
the initial ID, for example, just delete the ID macro that you don't want to do anything (see
Chapter 8 for macro definitions).
086: Recall Which Ports have ID's Enabled
This command lists the ports that have IDing enabled. If all ports do, it speaks "12345678".
<086>
Parameters:
- 086 is the default command name.
To Next Page
Loading...
Need help?
General
