9-2
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
049: Configure a Port's Tone Response when in Preaccess
This command allows the user to configure the frequencies of the tone response when in
preaccess mode. Normal response is to send dial tone in certain modes and warble tones in
other modes. The default response is dial tone.
<049> p xxxx yyyy
Parameters:
- 049 is the default command name
P is the port to assign the tone response
1 - Port 1
2 - Port 2
3 - Autopatch port
XXXX is the first tone of the 2-tone combination
YYYY is the second tone of the 2-tone combination
Default:
XXXX is 0440 hertz
YYYY is 0350 hertz
Response Name Tone 1 Tone 2
Dial Tone 0440 Hertz 0350 Hertz
Warble 0440 Hertz 0480 Hertz
To Next Page
Loading...
Need help?
General
