14-3
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Doug Hall Electronics
815 E. Hudson St.
Columbus, Ohio 43211
(614)261-8871
FAX 261-8805
INTRODUCTION
The DHE Remote Base Interface (RBI-1) Adapts the Kenwood series TM-X21 and TM-X31 mobile radios to
several brands of Repeater Controllers. The RBI model 1 converts the serial data stream from the Controller
and Directly controls the Kenwood Mobile radio. All connections to the Kenwood radio are made thru the
microphone jack. In the maximum configuration using a Kenwood TM-701 Dual Band Mobile you can control
Frequency, CTCSS encode On/Off, RF power level, Offset, Power On/Off, and Band. This is all
accomplished thru the microphone jack.
The RLC-Club Format supports the following functions:
• Full frequency control, 4 ports/radios, and 4 bands.
• Transmitter power HI/MED/LOW
• CTCSS Frequency select, Encode on/off, Decode on/off.
-20 and -12 Mhz offsets on 1200.
The Supported Kenwood Mobile Radios are as follows:
140 220 440 1200 Dual Band
TM-221 TM-321 TM-421 TM-521 TM-621+ TM-721+
TM-231 TM-331 TM-431 TM-531 TM-631+ TM-731+
TM-241 TM-441 TM-541 TM-701+
+ Dual Banders
SUPPORT CROSS REFERENCE
CTCSS CTCSS CTCSS MULTI RF PWR
FUNCTION ENCODE SELECT DECODE BAND POWER
GENERIC Y Y Y Y Y
TM-X21 Y N N N
TM-X31 Y Y Y Y
TM-X41 Y Y Y Y
TM-621/721 Y N N Y N
TM-631/731 Y N N Y N
TM-701 Y Y Y Y Y
Copyright (c) 1996 Doug Hall Electronics.
All Rights reserved
Specifications subject to change without notice
To Next Page
Loading...
Need help?
General
