8-10
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Automatic Macro Explanations
Macros 200..219 are where your error messages come from. Whenever an error occurs in the
controller, it will cause one of these macros to be executed. To find out what caused the error,
remember what the error number is and look at the description of the corresponding macro
number below. You can change the error messages to say anything you want them to, or
nothing at all, by changing these macros. Please note, however, that if you remove the error
messages completely, that you may not be able to tell when an error occurs. See the section
about error messages in Chapter 1 for more detailed descriptions.
Macro Definition . Macro Definition
200 No matching Command
Name
. 210 Invalid data value
201 Too few data digits . 211 Command does not exist
202 Too many data digits . 212 Bad Autopatch number
203 Invalid number of data digits . 213 Autopatch error
204 Execution blocked from port . 214 Invalid User
205 User level to low . 215 DVR is busy
206 Reserved . 216 Macro is full
207 Command executed OK . 217 Reserved
208 Internal problem . 218 Reserved
209 Macros depth problem . 219 Reserved
To Next Page
Loading...
Need help?
General
