8-14
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Macros 254..258 are called when Input 1..5 goes from High to Low. You may want to use
these macros to indicate an alarm condition. These macros are only called if the input alarms
are enabled with command 092 (see chapter 11). The input lines are the same as the analog
lines. Use the input line functions to read contact closure conditions.
Macro Definition
254 Input 1, High to Low
255 Input 2, High to Low
256 Input 3, High to Low
257 Input 4, High to Low
258 Input 5, High to Low
Macros 259..261 are called when the Time-Out Timer expires. You may want to program
these messages to indicate when a time-out condition occurred. They default to speaking "One
Time Out" (or whatever receiver it is that just timed out). To adjust the time out timers, see
Command 020.
Macro Definition
259 Port 1, Time-out Timer Message
260 Port 2, Time-out Timer Message
261 Autopatch, Time-out Timer Message
Macros 262..264 are called when the Time-Out Timer comes out of a time-out condition. You
may want to program these messages to indicate that a time-out condition has just been cleared.
Macro Definition
262 Port 1, Time-out Timer Message
263 Port 2, Time-out Timer Message
264 Autopatch, Time-out Timer Message
To Next Page
Loading...
Need help?
General
