1-16
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Error 211 - Command does not exist
This error is simular to error macro 200 except it occurs when a listed command that is
not enabled, is called. The command name exists but the command does not exist.
Error 212 - Bad Autopatch Number
You tried to enter a number in the autopatch that is invalid or blocked.
Error 213 - General Autopatch error
There is a general autopatch error that just occurred. Refer to the command you are
executing and verify the format or the autopatch is not configured (See Command 110)
Error 214 - User requested is disabled
This error is encountered if a user that is disabled tries to log-on to the system. A nice
voice message indicating the user is not enabled is a good used for this macro.
Error 215 - Digital Voice Recorder (DVR) is busy
This error is spoke if the DVR is currently busy and the requested DVR function can not
be processed.
Error 216 - Macro is full
This error indicates a macro position if full. No more commands can be added to the
specific macro.
Error 217 - HF Error
This error indicates that the last digits entered were not a valid HF command. It will
usually occur when you are in HF mode (see command 198). You will probably want to
disable this error message by deleting the contents of macro 217: "055 217" to avoid getting an
error message every time you enter an HF command wrong.
Error 218 - Reserved
Error 219 - Reserved
To Next Page
Loading...