4-6
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Transmitter Mini-Hang Timer:
This timer holds the transmitter PTT active for a minimum time after any keying source
(connected receiver, synthsized voice, tone, cw, DVR message, etc) goes inactive. It can be
used to keep the transmitter from dropping out immediately after a message. To control the
hang time after a connected receiver unkeys, you can also use the normal hang timers
(005..007); the actual hang time will be the longer of the two.
- This timer is programmed in 10mS increments from 000-9999
Timer Number Definition Defaults
016 Mini-Hang Timer, Transmitter 1 1/2 sec (50)
017 Mini-Hang Timer, Transmitter 2 "
018 Mini-Hang TimerAutopatch "
Initial ID Timer:
This timer times the amount of inactivity before an initial ID is sent.
- This timer is programmed in 1Sec increments from 001-9999
- If a timer value of 000 is entered, the controller will never send an initial ID.
Timer Number Description Defaults
022 Initial ID Timer, Transmitter 1 10 min (600)
023 Initial ID Timer, Transmitter 2 "
Pending ID Timer:
This timer times inner activity ID timer so a proper Pending ID can be send during activity.
- This timer is programmed in 1Sec increments from 001-9999
- If a timer value of 000 is entered, the controller will never send a rotating ID.
- This timer should normally be set shorter than the initial ID timer (one minute shorter works
well). You may need to make sure that the length of this timer plus the length of the impolite
ID timer is less than 10 minutes to meet requirements for ID timing.
Timer Number Description Defaults
024 Pending ID Timer, Transmitter 1 9 min (540)
025 Pending ID Timer, Transmitter 2 "
To Next Page
Loading...