ASSEMBLING THE WINDROWER
4. Drive the windrower slowly forward until the win drower
feet (A) enter the header boots (B). Continue driving
slowly forward until the feet engage the boots and the
header nudges forward.
Figure 3.223: Header Boot
5. Use the following ground speed lever functions
to position the center-link hook above the header
attachment pin:
• Header tilt up (A) to retract center-link
• Header tilt down (B) to extend center-link
6. Stop engine and remove key from ignition.
Figure 3.224: Ground Speed Lever
7. Push down on rod end of link cylinder (B) until hook
engages and locks onto header pin.
IMPORTAN T:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually
push it down after hook engages header pin.
8. Check that center-link (A) is locked onto header by
pulling upwa r d on rod end (B) of cylinder.
Figure 3.225: Hydraulic Center-Link
147962 123 Revision A
To Next Page
Loading...
