CAB DISPLAY MODULE (CDM)
6. Press right (C) arrow to select YES. Press
SELECT (D).
• SENSOR INPUT is displayed on the upper line.
• HDR HEIGHT 1.23 V is displayed on the lower line.
7. Press left (B) or right (C) arrow to cycle between
individual sensor readers.
8. Press SELECT (D) to skip to EXIT REA D
SENSORS? selection.
Figure 4.2
56: M105 Header Sensors
Figure
4.257: M155 Header Sensors
Figure 4.258: M205 Header Sensors
9. Press right arrow t o select YES. Press SELECT.
10. Press PROGRAM to exit Programming Mode or press
SELECT to proceed to next DIAGNOSTIC MODE.
147962 263 Revision A
To Next Page
Loading...
