Driving mode
5.2 Operating the transmission
5 - 32 3 302 819 en Operating manual
GMK3060
13.12.2018
Automatic downshifting
– When you slow down the truck crane by braking, the transmission shifts down
when the appropriate engine speed is reached.
– If you fully depress the accelerator full (kick down), the transmission first shifts
to a lower gear. After that, it will shift to a higher gear only once a higher engine
speed has been reached, so as to achieve maximum acceleration.
If you execute a manual gear change using the gearshift lever, you simultane-
ously switch to Manual operating mode.
The transmission will only perform an automatic shift after you have switched to
Automatic operating mode (push the gearshift lever to the left once).
In Manual
operating mode
In this operating mode, the transmission only shifts when you actuate the
gearshift lever.
Manual upshifting
To upshift, you must pull the gearshift lever upwards briefly:
The newly engaged gear will be shown in the display.
Manual downshifting
To downshift, you must press the gearshift lever downwards briefly:
The newly engaged gear will be shown in the display.
H
If you initiate a gear change which would cause the maximum permitted engine
speed to be exceeded, the transmission does not shift.
In that case, slow the truck crane down until a permissible engine speed is
reached, and downshift again.
– Upshifting one gear: Push forwards once
– Upshifting two gears: Briefly push forwards twice
– Upshifting three gears: Briefly push forwards three times
– Shift one gear down: Push backwards once
– Shift two gears down: Briefly push backwards twice
– Shift three gears down: Briefly push backwards three times
To Next Page
Loading...
Need help?
General
