Driving with a rigged truck crane
13.4 Driving from the driver's cab
Operating manual 3 302 819 en 13 - 9
GMK3060
13.12.2018
13.4 Driving from the driver's cab
13.4.1 Preparing to drive
Transmission
• Switch to the lowest starting gear and remain in the Manual operating mode;
à p. 5 - 29.
In this way you prevent the gears changing up and ensure that the speed is kept
to a minimum.
Switching on
separate steering
When driving the rigged truck crane, the separate steering must be switched on.
• Select and confirm the symbol
s
G
Risk of accidents when driving the truck crane from the driver's cab with a
lifted load!
With a lifted load, drive the truck crane only from the crane cab. You must be able
to carry out crane movements in an emergency at all times.
S
Risk of damage to the steering linkage!
Always switch on separate steering before driving the rigged truck crane and
steer the truck crane only when it is rolling.
The steering linkage can be damaged if separate steering is switched off or if you
steer the vehicle while it is stationary.
1 – for Manual separate steering or
2 – separate steering automatic for driving around corners or
3 – separate steering automatic for crab travel mode.
To Next Page
Loading...
Need help?
General
