Basic safety instructions
2.5 Safety instructions for crane operation
Operating manual 3 302 819 en 2 - 7
GMK3060
13.12.2018
Check all operating and control elements in the driver's cab before starting the
engine.
After starting the engine, take note of all the lights and control elements.
After driving, secure the truck crane against unauthorised use.
2.5 Safety instructions for crane operation
Carefully select a safe site for the truck crane, where you can work safely.
Walk around the truck crane and inspect it before beginning crane operation.
Check the condition of the truck crane carefully using the checklists in the
operating manual. Do not assume everything is in working order simply because
it was in working order at the end of the last shift.
Check daily that all covers and safety devices are fitted properly and are in good
condition before crane operation.
Check the safety devices (RCL, lifting limit switch, dead man's switch, emergency
stop switches) every day before you start work.
Use the appropriate access aids when carrying out overhead rigging or mainte-
nance work. Do not use parts of the crane as access aids.
Walk on only those parts of the truck crane which are equipped with appropriate
step grids and railings and therefore guarantee safety.
Use a suitable safety harness when walking on other surfaces – this also applies
to sanded surfaces.
All locations designed for fastening a fall prevention safety system are marked
with a symbol.
Always use a ladder for work above head height.
s
To Next Page
Loading...
Need help?
General
