Driving with a rigged truck crane
13.5 Driving from the crane cab
13 - 14 3 302 819 en Operating manual
GMK3060
13.12.2018
13.5.1 Preparing to drive
•
Make sure that the rigging mode for driving with a load or without a load is set
correctly;
à p. 13 - 2.
In the driver's cab
– The ignition key must be in position 1 so that the steering cannot block.
– The driver's cab must be locked with the second ignition key in order to secure
it against unauthorised use – for example, braking.
– The parking brake is engaged.
In the crane cab
– The ignition must be switched on.
– The hand-held control must be disconnected and bridging plugs plugged into
all the sockets.
– The superstructure must be locked.
– The parking brake is engaged.
To Next Page
Loading...
