Overview
1.7 Notes on the operating manual
Operating manual 3 302 819 en 1 - 23
GMK3060
13.12.2018
1.7.2 How is the operating manual structured?
Division – The chapters 1 to 8 contain a description of how to drive the truck crane.
– Chapters 9 to 15 contain a description of crane operation.
The complete operating manual must always be carried in the truck crane.
The basic safety instructions, also for crane operation, are included in Chapter 2
only. Please read these safety instructions and observe them.
Structure of
the chapters
Chapters 3 and 9 are structured in relation to the product, and give an overview
of all operating elements on the truck crane. You will find cross-references to the
associated brief descriptions, and from there, to further chapters.
Chapters 4 to 8 and 10 to 14 describe procedures, and are therefore structured
in relation to these operations. For more extensive processes, the description is
given with checklists and operating instructions.
– The checklists show the procedure in the required sequence, for example, for
rigging work. From there, cross-references take you to the corresponding oper-
ation descriptions.
– The operation descriptions describe the work in detail, including the required
warnings and safety instructions.
You are obliged to read these sections before using the truck crane for the first
time and if you are still unsure about how to operate the truck crane.
s
G
Risk of accidents when only referring to the checklists during operation!
The checklists and operating instructions should always be regarded as a single
unit for the comprehensive description of the rigging.
It is only safe to operate the truck crane by referring to the checklists when you
are familiar with all the dangers which may occur, and are confident in complet-
ing the necessary steps as described in the relevant operating instructions.
If in doubt, always first read the section which is referred to in the checklist.
To Next Page
Loading...
Need help?
General
