Starting/switching off the engine – for crane operation
10.2 Starting the engine – from the crane cab
Operating manual 3 302 819 en 10 - 9
GMK3060
13.12.2018
10.2.9 Setting idling speed
•
Start the engine; Ã p. 10 - 7.
• Open the start menu – button (1).
The display (2) shows the current engine speed.
You can increase the idling speed for crane operation.
Release the accelerator in order to be able to view the settings below the current
engine speed.
Increasing the idling speed
• Press the button (1) in at the top.
The idling speed increases continuously until you release the button or the
maximum value is reached.
or
• Press the button in at the top once.
The idling speed is increased by one step.
Reduces the idling speed
• Press the button (1) in at the bottom once.
The idling speed is reduced by one step.
or
• Press the button (1) in at the bottom and hold it pressed.
– After about 3 seconds the idling speed will be at the standard value.
– After a further approx. 3 seconds, the engine will switch off.
It is only possible to restart the engine when approx. 7 seconds have
elapsed.
Exceeding the idling speed
You can exceed the idling speed at any time using the accelerator.
Once you release the accelerator the engine speed reduces to the pre-set idling
speed.
To Next Page
Loading...
Need help?
General
