Rigging work
12.7 Rigging work on the main boom
Operating manual 3 302 819 en 12 - 77
GMK3060
13.12.2018
12.7 Rigging work on the main boom
12.7.1 Hook block on the bumper
When the hook block is transported on a separate vehicle; Ã p. 12 - 79.
Picking up the
hook block
Depending on the driving mode, you must pick up the hook block from the front
bumper;
à Driving modes, p. 6 - 1.
The main boom must be fully retracted.
• Enter and confirm the current rigging mode.
• Slacken the hoist rope and raise the main boom
simultaneously.
• Raise the main boom until the boom head is in
a vertical position above the hook block.
• Detach the hook block from the retaining
rope (1).
s
S
Risk of accidents if the view is obstructed!
Have someone instruct you when raising the main boom, since the view of the
hook block is obstructed. That way you will not raise the boom too far, which
would cause the retaining rope to tear.
To Next Page
Loading...
Need help?
General
