Malfunctions during crane operation
14.5 Emergency operations and programs
Operating manual 3 302 819 en 14 - 41
GMK3060
13.12.2018
14.5.3 Entering the current telescoping
CCS no longer displays the current telescoping,
– if you telescoped in emergency mode, or
– if the power supply was interrupted in the course of saving data.
In these cases, you must enter the current telescoping, e.g. the values from the
RCL display.
• Select and confirm the symbol (1) – the Unknown telescoping menu opens.
• Select and confirm the symbols (1) to (4).
• Confirm the entry with the symbol (5).
You can cancel the entry at any time using the (6)
or (7) buttons.
After the correct input, the area for the set value
input will be opened.
Entering target values
• Select and confirm the symbols for telescopic
sections 1 to 5 one after another.
• Enter the desired target values for all telescopic
sections, for example, Unlocked, 100%, 100%,
100%, 100%.
• Confirm the entry with the symbol (1).
Display symbol:
s
2 Permissible values
3 Impermissible values
To Next Page
Loading...
Need help?
General
