Crane operation
11.4 Operation of the rated capacity limiter
11 - 68 3 302 819 en Operating manual
GMK3060
13.12.2018
When rigging For rigging work, you can:
– Override the lifting limit switch;
à p. 11 - 89
or
– override the RCL and thus enable a degree of utilisation of up to 110%.
RCL override
• Press the button (1) once – the information
message (2) is displayed.
– Now a degree of utilisation of up to 110% is
enabled.
– If you do not trigger a control lever movement
within 10 seconds after the override, you must
press the button (1) again.
– The power unit speeds are reduced to 15%.
Cancelling the override
The override will be cancelled when you:
– press button (1) again, or
– do not activate the control lever for 10 seconds, or
– switch off the ignition.
S
Risk of accidents if the RCL is overridden!
It is not permitted to work with an overridden RCL!
Use this type of override only for rigging.
To Next Page
Loading...
Need help?
General
