Basic safety instructions
2.2 Organisational measures
2 - 4 3 302 819 en Operating manual
GMK3060
13.12.2018
Observe the operational organisation at the site. Report your arrival to site
management. Ask for the personnel authorised to instruct you.
Find out where the fire extinguishers are and how to operate them at every site.
Note the fire alarm and fire-fighting facilities.
Should the operating behaviour of the truck crane change in such a manner that
safety is impaired or if you are in doubt about the operational safety of the truck
crane, stop the truck crane immediately and inform the responsible departments
or persons.
Do not make any changes to the programmable control systems (e.g. the RCL).
Do not modify or retrofit additional units to the truck crane without the consent of
the manufacturer if such changes would affect the safety. This also applies to:
– Installation of safety devices
– Adjustment of safety devices and valves
All welding work (especially on load carrying members) may only be performed
by qualified professional personnel with the prior written permission of
Manitowoc Crane Group Germany GmbH.
To avoid damage, especially to electronic parts, there are certain measures you
must take before doing any welding work. You should therefore always consult
Manitowoc Crane Care before carrying out any welding work.
Make sure that the prescribed intervals and the intervals specified in the opera-
tion and maintenance manual for periodic inspections, tests and maintenance
work are adhered to.
Replace the hydraulic hose lines, or have them replaced, at the prescribed
intervals, even if no safety defects are noticeable.
Be sure to follow the instructions in the maintenance manual relating to corrosion
protection of the hydraulic cylinders.
Spare parts must fulfil the technical requirements defined by the manufacturer.
Genuine spare parts always meet these requirements.
To Next Page
Loading...
Need help?
General
