Basic safety instructions
2.6 Instructions on transporting persons
2 - 12 3 302 819 en Operating manual
GMK3060
13.12.2018
The person being transported must be in radio contact with the crane operator.
When used for transporting persons, the truck crane must not be used for other
tasks.
The crane operator is not permitted to exceed the maximum permissible wind
speeds and wind loads for transporting persons applicable in the country in which
he is working. These values are normally lower than those for lifting loads speci-
fied in the Lifting capacity table.
When the equipment for lifting persons is being used and is in a stationary posi-
tion, then the slewing gear, hoist, derricking gear and telescoping mechanism
must be secured against accidental use by being switched off.
Truck crane The truck crane must be equipped (e.g. with hydraulic emergency operation) so
that the equipment for lifting persons can be set down and the persons being
transported can safely leave it even if there is a failure of the drive or crane
controls.
The hook holding the lifting gear for the equipment for lifting persons must be
fitted with a lockable latch that completely seals the hook opening.
The truck crane must be serviced as prescribed, regularly inspected and
repaired, if required. All safety stickers must be affixed in their appropriate
places and be legible.
To Next Page
Loading...
Need help?
General
