Malfunctions during crane operation
14.5 Emergency operations and programs
14 - 44 3 302 819 en Operating manual
GMK3060
13.12.2018
Connection • Switch off the engine
H
Pulling a bridging plug will shut the engine off, but this action is only designed for
emergencies.
Connecting the hand-held control
• Open the cap (2) and remove the bridging plug
(3) from the socket (1).
• Insert the plug (5) into the socket (1) and secure
it with the lock (2).
• After about 20 seconds, the lamps (4) light up –
the ignition is now switched on.
If the lamp (4) does not light up or if it flashes,
there is a malfunction;
à p. 14 - 23.
Disconnecting the hand-held control
• Open the cap (2).
• Remove the plug (5) from the socket (1) –
the lamps (4) will go out.
• Insert the bridging plug (3) into the socket (1)
and secure it with the cap (2).
The ignition is switched off, unless it is switched
on at an ignition lock.
To Next Page
Loading...
