MR TAPCON - Page 331

List of key words
Maschinenfabrik Reinhausen GmbH 2020 3313587317/21 EN TAPCON
®
O
Ohmic resistance load 174
OLTC
Information 224
Operating controls 28
Operating mode
Auto mode 26
Local mode 26
Manual mode 26
Remote mode 27
Operations counter 210
OT1205 35
Outputs
Analog 232
Digital 235
Overview of parameters 301
Overvoltage 199
P
Parallel operation 179, 188
CAN bus 189
Circulating reactive current 182
Information 249
Parallel operation error mes-
sage 191
Power factor 183
Tap stagger 184
Tap synchronization 180
Parallel operation method 188
Parity 105, 108, 112
Password 242
Password 96
Percentage 201, 204
Phase angle correction 161
Pos behavior 210
Pos. at max. analog signal 177
Pos. at min. analog signal 178
Pos</Pos> follower 193
power factor 183
Power flow
Negative 207
Power flow monitoring 207
Power monitoring 205
Prim/sec topology 197
Primary transformer current 160
Primary transformer voltage 160
PTP 97, 98
PTP hops 98
PTP interface 98
PTP version 98
Q
Quick search 43
R
R&X compensation 173
RADIUS 246
Reaction 202, 205, 206
Reactive power regulation 156
Reactive power regulation switch-
ing direction 135
Reconnect delay time 100
Recorder 218
Average value interval 223
Rectifying faults 274
Reference time107, 109, 110, 115
Regulation mode 172
Remote behavior 90
Repeat unsolicited messages in-
definitely 114
Repetition of unsolicited messages
114
RES bit test 106
Response to SCADA disconnec-
tion 137
Retrofit TAPCON® 2xx 194
Reversal of power flow 207
RFC 3164 99
RFC 5424 99
S
SCADA 102
SCADA disconnection delay time
137
Screensaver 100, 101
Screensaver waiting time 101
Secondary transformer voltage
160
Select tap stagger setting 192
Serial interface 104, 107, 112, 113
Service user access 92
Service user access activation 92
setting of the desired value
analog 140
Step-by-step 141
Severity level 100
SNTP 97
SNTP time server 97
SNTP time server 2 98
Software
Information 248
SSL/TLS encryption 94, 96
Standard AVR mode 138
Stop bits 105, 108, 112
Subnet mask 93
SW 3-3 40
Configuration 253
Switching direction monitoring 135
Switching interval monitoring 215
Switching pulse pause 133
Switching pulse time 133
Switching pulse type 132
Switching statistics 224
Synchronization interval 97
Syslog 99
Syslog server 100
Syslog server port 100
Syslog standard 99