1 Introduction
Customers of Nanotec Electronic US Inc. please refer to us.nanotec.com/service/general-terms-and-
conditions/.
Note
Changes or modifications to the product are not permitted.
1.6 EU directives for product safety
The following EU directives were observed:
●
RoHS directive (2011/65/EU, 2015/863/EU)
●
EMC directive (2014/30/EU)
1.7 Other applicable regulations
In addition to this technical manual, the following regulations are to be observed:
●
Accident-prevention regulations
●
Local regulations on occupational safety
1.8 Used icons
All notices are in the same format. The degree of the hazard is divided into the following classes.
CAUTION
!
The CAUTION notice indicates a possibly dangerous situation.
Failure to observe the notice may result in moderately severe injuries.
►
Describes how you can avoid the dangerous situation.
Note
Indicates a possible incorrect operation of the product.
Failure to observe the notice may result in damage to this or other products.
►
Describes how you can avoid the incorrect operation.
Tip
Shows a tip for the application or task.
1.9 Emphasis in the text
The following conventions are used in the document:
Underlined text indicates cross references and hyperlinks:
●
The following bits in object 6041
h
(statusword) have a special function:
●
A list of available system calls can be found in chapter System calls in a NanoJ program.
Text set in italics marks named objects:
●
Read the installation manual.
●
Use the Plug & Drive Studio software to perform the auto setup.
Version: 2.0.1 / FIR-v1650 10
To Next Page
Loading...