2 Safety and warning notices
2 Safety and warning notices
Note
●
Damage to the controller.
●
Changing the wiring during operation may damage the controller.
●
Only change the wiring in a de-energized state. After switching off, wait until the capacitors have
discharged.
Note
Fault of the controller due to excitation voltage of the motor!
Voltage peaks during operation may damage the controller.
►
Install suitable circuits (e.g., charging capacitor) that reduce voltage peaks.
Note
Damage to the electronics through improper handling of ESD-sensitive components!
The device contains components that are sensitive to electrostatic discharge. Improper handling
can damage the device.
►
Observe the basic principles of ESD protection when handling the device.
Note
●
There is no polarity reversal protection.
●
Polarity reversal results in a short-circuit between supply voltage and GND (earth) via the power
diode.
●
Install a line protection device (fuse) in the supply line.
Version: 2.0.1 / FIR-v1650 12
To Next Page
Loading...