NEC Aspila Topaz - 14-09: Conversation Recording Destination for Trunks

96
Programming Manual
Program 14: Trunk Basic Setup
14-09: Conversation Recording Destination for Trunks
IN
SA
SB
COP
Y
Description
Use Program 14-09 : Conversation Recording Destination for Trunks to set the Conversation Recording
destination for each trunk.
Note: If both Programs 14-09 and 15-12 define a destination, the destination in Program 15-12 will be followed.
Input Data
Trunk Port Number
1-51
Prog. No. Item Input Data Default
14-09-01
Recording Destination Extension Number
Extension Number
(Up to 4 digits)
No
setting
14-09-02
Automatic Recording
0 : Off
1 : On
0
14-09-03
Recording Contents Storing Method
0 : Specifies by Dialing
1 : Own Mailbox
0
14-09-04
Automatic Recording for Outgoing Call
0 : Off
1 : On
0
 If automatic telephone call recording is set-up, the recording will be started from the time of answering an
incoming call
.
 If the PRG14-09-04 is set to “1” , the recording will be started from the time of answering an outgoing call.
 In case of Conversation recording by the SLT;
If the recording destination is set to Voice Mailbox, the service of the feature is only available for the Automatic
Conversation Recording and the conversation recording is automatically storing to own mailbox.
Conditions
None
Feature Cross Reference
 Voice Mail
Telephone Programming Instructions
To enter data for Program 14-09(Conversation Recording Destination for Trunks):
1. Enter the programming mode.
2. Enter 14 09
3. Enter the number of the item you want to program.
4. Select the Trunk port number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
14-09-01 Trunk1
Rec Dest Ext
14-09-xx Trunkxx
xxxxx