NEC Aspila Topaz - 15-08: Incoming Virtual Extension Ring Tone Setup

112
Programming Manual
Program 15: Extension Basic Setup
15-08: Incoming Virtual Extension Ring Tone Setup
IN
SA
SB
COP
Y
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a ring tone range (0-4) to incoming
virtual extensions assigned to a Virtual Extension key (Program 15-07). If you enable ringing for the key in Program
15-09, the key rings with the tone you set in this program. Also see Program 22-03. The chart below shows the
available tones.
Input Data
Extension Number
Max. 4 digits
Incoming Ring Pattern Default Description
0 : Tone Pattern 1
1 : Tone Pattern 2
2 : Tone Pattern 3
3 : Tone Pattern 4
4 : Incoming Extension Ring Tone
0 :
Tone Pattern 1
When an extension or a virtual extension is assigned to
the function key on the key telephone, select the ring tone
when receiving a call on that key.
Incoming Signal Frequency Pattern Frequency Modulation
0: Tone Pattern 1 600/450/16Hz FM
1: Tone Pattern 2 450/16Hz AM
2: Tone Pattern 3 600Hz
-
3: Tone Pattern 4 600/450/16Hz FM
4: Internal Incoming Signal Frequency
Conditions
None
Feature Cross Reference
 Multiple Directory Number/ Call Coverage