NEC Aspila Topaz - 25-03: DID;DISA Transfer Ring with Incorrect Dialing

229
Programming Manual
Program 25: DID/DISA Setup
25-03: DID/DISA Transfer Ring with Incorrect Dialin
g
SA
SB
IN
Description
Use Program 25-03 : DID/DISA Transfer Ring Group with Incorrect Dialing to set what happens to a call when
the DISA caller dials incorrectly or waits too long to dial. The call can either disconnect (0) or Transfer to an
alternate destination (a ring group or voice mail). When setting the DISA and DID Operating Mode, you make an
entry for each Night Service mode.
Input Data
Trunk Port Number
1-51
Day/Night Mode Incoming Group Number Default Related Program
1-8
0 : Disconnect
1-25 : Incoming Ring Group
101 : (DSPDB-VM)
022-04
Conditions
None
Feature Cross Reference
 Direct Inward System Access (DISA)
Telephone Programming Instructions
To enter data for Program 25-03(DID/DISA Transfer ring Group with Incorrect Dialing):
1. Enter the programming mode.
2. Enter 25 03
3. Enter the number of the item you want to program.
4. Select the Trunk port number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
25-03-01TrkPrt1
Mode1 IRG No=0
25-03-xxTrkPrtxx
xxxxx