87
Programming Manual
Program 14: Trunk Basic Setup
14-02: Analogue Trunk Data Setup
IN
SA
SB
COP
Description
Use Program 14-02 : Analogue Trunk Data Setup to set the basic options for each analogue trunk port. Refer to
the chart below for a description of each option, its range and default setting.
Input Data
Trunk Port Number
1-51
Prog. No. Item Input data Default
Related
Program
14-02-01
Signaling Type(DP/DTMF)
This option sets the signaling type for the trunk.
0 : Dial Pulse (10pps)
1 : Dial Pulse (20pps)
2 : DTMF
2
14-02-02
Ring Detect Type
This option to sets Extended Ring Detect or
Immediate Ring Detect for the trunk.
0 : Normal/ Delayed
1 : Immediately
ringing
0
14-02-03
Flash Type
This option to select the Flash type (open loop
flash or ground). Always set this option for open
loop flash.
0 : Open Loop Flash
1 : Ground
0
14-02-04
Flash for Timed Flash or Disconnect
This option lets you use Flash for Timed Flash
(Program 81-01-14) or Disconnect (Program 81-
01-15). (A user implements Flash by pressing the
FLASH key while on a trunk call.)
0 : Timed Flash
1 : Disconnect
1
14-02-05
Dial Tone Detection for Directly Accessed
Trunks
Use this option enable/disable dial tone detection
for directly accessed trunks. If disabled, the system
out dials on the trunks without monitoring for dial
tone.
0 : DTD not used
1 : DTD used
1
14-02-06
Pause at 1
st
digit after line seize in manual dial
mode
0 : No Pause
1 : Pause
1
14-02-07
DP to DTMF Conversion Options
Determine how a user can convert a Dial Pulse
(DP) call to a DTMF call. For each trunk, set the
type of DP to DTMF conversion required. There
are three conversion options: Automatic (0),
Automatic and Manual (1), or Manual (2).
Automatic: DP to DTMF conversion occurs
automatically if the extension user waits more than
10 seconds before dialing the next digit.
Automatic and Manual: DP to DTMF conversion
occurs automatically if the extension user waits
more than 10 seconds before dialing the next digit.
In addition, the user can dial # to switch a DP trunk
to DTMF dialing.
Manual: User can dial # to switch a DP trunk to
DTMF dialing
0 : Automatic
1 : Automatic and
Manual
2 : Manual
221-01-03
14-02-08
Answering Condition 0 : Polarity reversing
1 : Polarity reversing
or timer
1
21-01-03
To Next Page
Loading...
