88
Programming Manual
Program 14: Trunk Basic Setup
14-02: Analogue Trunk Data Setup
IN
SA
SB
COP
Input Data(Cont’d)
Prog. No. Item Input data Default
Related
Program
14-02-09
Busy Tone Detection 0 : Disable
1 : Enable
0
14-02-10
Caller-ID
Enable or Disable a trunk’s ability to receive
Caller ID information
0 : Disable
1 : Enable
0
14-02-11
Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the system’s
ability to skip over a trunk if dial tone is not
detected. This option pertains to calls placed using
Loop Keys, Speed Dial, ARS, Last Number Redial
or Save Number dialed. It does not pertain to line
key or Direct Trunk Access calls.
0 : Disable
1 : Enable
0
14-02-12
Detect Network Disconnect Signal
0 : Disable
1 : Enable
0
14-02-13
Trunk-to-Trunk Limitation
0 : Disable
1 : Enable
0
14-02-14
Loop Start/Ground Start
0 : Loop Start
1 : Ground Start
0
14-02-15
-Not Used- -
-
-
14-02-16
Caller-ID Type for Analogue Trunk
0 : FSK
1 : DTMF
0
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 14-02(Analogue Trunk Data Setup):
1. Enter the programming mode.
2. Enter 14 02
3. Enter the number of the item you want to program.
4. Select the Trunk port number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
14-02-01 Trunk1
DP/DTMF 1
14-02-xx Trunkxx
xxxxx
To Next Page
Loading...
