156
Programming Manual
Program 20: System Option Setup
20-18: Service Tone Timers
IN
SA
SB
Description
Use Program 20-18 : Service Tone Timer to set the values for the system service tone timers.
Refer to the following chart for a description of each option, its range and default setting.
Input Data
Prog. No. Item Input data Default Description
Related
Program
20-18-01
Extension Dial
Tone sending
Timer
0 - 64800(sec.) 30 After getting Intercom dial tone, a
KTS user has this interval to dial
the first digit of the Intercom call.
20-18-02
Busy Tone sending
Timer
0 - 64800(sec.) 15
20-18-03
Congestion Tone
sending Timer
0-64800(sec.) 10 A Busy Tone when system
resources run short. (such as
DTMF receiver resources)
20-18-04
Warning Tone
sending Timer
0-64800(sec.) 10 This option sets the interval
between Call Waiting tones.
This timer also sets the interval
between Off Hook Signaling
alerts.
20-18-05
KTS Confirmation
Tone sending Timer
0-64800(sec.) 10
20-18-06
Interval of Call
Waiting Tone
0-64800(sec.) 10
20-18-07
Intrusion Tone 0-64800(sec.) 0 After a call is interrupted (such as
Barge In, Voice Mail
Conversation Recording, Voice
Over, etc), the system repeats the
Intrusion Tone after this interval.
Normally, you should enter 0 to
disable this interval.
20-18-08
Conference tone
Interval
0-64800(sec.) 0
20-18-09
Warning Beep Tone
Signaling Interval
0-64800(sec.) 60 14-01-18
Conditions
None
Feature Cross Reference
Distinctive Ringing, Tones, and Flash Patterns
To Next Page
Loading...
