22
Programming Manual
Program 10: System Configuration Setup
10-08: Pre-ringing Setup
IN
SA
SB
COP
Description
Use Program 10-08 : Pre-Ringing Setup to enable or disable pre-ringing for trunk calls. This sets how a trunk
initially rings a telephone. With pre-ringing, a burst of ringing occurs as soon as the trunk’s LED flashes. The call
then continues ringing with the normal ring cadence cycle. Without pre-ringing, the call starts ringing only when the
normal ring cadence cycle occurs. This may cause a ring delay, depending on when call detection occurs in
reference to the ring cycle.
Input Data
Input Data Default
0 : disable
1 : enable
0
Conditions
None
Feature Cross Reference
Central Office Calls, Answering
Telephone Programming Instructions
To enter data for Program 10-08 (Pre-Ringing Setup):
1. Enter the programming mode.
2. Enter 10 08
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
10-08-01
Pre-ringing
10-08-xx
xxxxx
To Next Page
Loading...
