NEC Aspila Topaz - PRG 26: ARS Service & Least Cost Routing; 26-01: Automatic Route Selection Service

243
Program 26:
A
RS Service & Least Cost Routin
g
26-01: Automatic Route Selection Service
Programming Manual
SA
SB
IN
Description
Use Program 26-01 : Automatic Route Selection Service to define the system options for Automatic Route
Selection (ARS).
Input Data
Prog. No. Item Input Data
Default
Related
Program
26-01-01
ARS Service
Enable or disable ARS
0 : Disable
1 : Enable
026-02
26-03
26-04
26-01-02
Network Outgoing Inter-Digit ARS Timer
With Networking, this timer replaces 20-03-04
when determining if all network protocol digits
have been received. If ARS is enabled at Site B,
this timer can be programmed for 5 (500 msec) at
Site A. If ARS is disabled and Site B is using F-
Route for outbound dialing, this timer should be
programmed for 30 (3 seconds) at Site A.
0-64800(x 100ms) 30(3 sec.) 20-03-04
26-01-03
ARS Misdialed Number Handling
If a user dials a number not programmed in ARS,
this option determines if the system should route
over trunk group 1 or play error tone.
0 : Route to Trunk
Group
1 : Play Warning
Tone to Dialer
021-02
26-01-04
LCR Mode
Use this option to define the operation of dialed
numbers beginning with digit 1.
0 : UK Mode
1 : Not UK Mode
026-02
26-05
26-06
26-07
26-08
26-09
Conditions
None
Feature Cross Reference
 Automatic Route Selection (ARS)