NEC Aspila Topaz - 26-05: LCR Carrier Table

249
Programming Manual
Program 26:
A
RS Service & Least Cost Routin
g
26-05: LCR Carrier Table
SA
SB
IN
Description
Use Program 26-05 : LCR Carrier Table to define the LCR Access Codes and routing options.
These options include Authorization codes and Cost Centre Codes.
Input Data
Carrier Table Number
1-25
Prog. No. Description Input Data Default
Related
Program
26-05-01
Delete Digits
Enter the quantity of leading digits
that need to be deleted
0-16
0
26-05-02
Access Code
Enter the Access Code and Option to
route to the Indirect Carrier
Max. 16 digits (0-9,*,#,@,Pause)
No setting
26-05-03
Authorization Code Table
Enter the table number that contains
the correct Authorization code.
0-10
0
26-05-04
Cost Centre Code
Optionally enter a cost centre code.
0 : Not used
1 : Used
0
Conditions
The settings must comply with the requirements of the Indirect Carrier.
The operation of the @ symbol within the Access Code depend on the type of trunk. For analogue trunk set as Dial
Pulse the @ symbol defines change to DTMF dialing. For ISDN trunks the @ symbol defines that a Connect
Message is received and then DTMF digits are sent in the B-Channel.
Feature Cross Reference
 Least Cost Routing
Telephone Programming Instructions
To enter data for Program 26-05(LCR Carrier Table):
1. Enter the programming mode.
2. Enter 26 05
3. Enter the number of the item you want to program.
4. Select the Carrier Table number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
26-05-01CarTBL1
Delete digit 0
26-05-xx
CarTBLxx