NEC Aspila Topaz - 90-20: Traffic Report Data Setup

370
Programming Manual
Program 90: Maintenance Program
90-20: Traffic Report Data Setup
IN
SA
SB
Description
Use Program 90-20 : Traffic Report Data Setup to define the details of the traffic report.
Input Data
Prog.No. Item Input Data Default
90-20-01 Call Traffic Output
0 : Not measured
1 : Measured
0
90-20-02 -Not Used- - -
90-20-03 All Line Busy Output 0
90-20-04 DTMF Receiver Busy Output 0
90-20-05 Dial Tone Detector Busy Output 0
90-20-06 Caller-ID Receiver Busy Output 0
90-20-07 Voice Mail Channel All Busy Output 0
90-20-08 -Not Used- -
90-20-09 Attendant Channel All Busy Output 0
90-20-10 Base Station All Busy Output
0 : Not detected
1-256 : (Report when the
data is reached to the
defined value)
-
0
Conditions
None
Feature Cross Reference
 Traffic Management Reporting(TMS)
Telephone Programming Instructions
To enter data for Program 90-20 (Traffic Report Data Setup):
1. Enter the programming mode.
2. Enter 90 20
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
90-20-01
Call Traffic 0
90-20-xx
xxxxx