23
Programming Manual
Program10: System Configuration Setup
10-09: DTMF and Dial Tone Circuit Setup
IN
SA
SB
COP
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on the 308M PCBs for either
DTMF receiving or dial tone detection. The 308M PCB has 16 circuits initially.
With additional DSPDBU is installed in 924M Main Cabinet, the system can provide a total of 32 (16+16) circuits.
These are used as follows:
• Extension : DTMF receiver for SLT
• Trunk : DTMF receiver for analogue trunks, dial tone & busy tone detection for analogue trunks
Input Data
Circuit/ Resource Number
Input Data Default
01-96 0 : Common Use
1 : Extension Only
2 : Trunk only
Resource 01-96 = 0(Common)
*In case of 924M system:
01-32(Including DSPDBU:16+16)
*In case of 924M+924ME:
01-64
*In case of 924M+924ME+924ME:
01-96
Conditions
None
Feature Cross Reference
Central Office Calls, Placing
Direct Inward Dialing (DID)
Direct Inward System Access(DISA)
Telephone Programming Instructions
To enter data for Program 10-09 (DTMF and Dial Tone Circuit Setup):
1. Enter the programming mode.
2. Enter 10 09
3. Enter the number of the item you want to program.
4. Select the Resource Number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
10-09-01 Res 1
DTMF DT Detect
10-09-xx Resxx
xxxxx
To Next Page
Loading...
