NEC Aspila Topaz - 22-11: DID Translation Number Conversion

203
Programming Manual
Program 22: Incoming Call Setup
22-11: DID Translation Number Conversion
SA
SB
IN
Description
Use Program 22-11 : DID Translation Number Conversion to specify for each Translation Table entry (2000):
• The digits received by the system (eight max.)
• The extension the system dials after translation (36 digits max.)
• The name that should show on the dialed extension’s display when it rings (twelve characters max.)
• The Transfer Target-1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer destination
(Program 22-10).
• Operation mode
Use the following chart when entering and editing text for names. Press the key once for the first character, twice for
the second character, etc. For example, to enter a C, press “2” three times.
Number of pressing the Key
Key
12345678910111213
1
1@[ ¥ ] ^ _ ` { | }
2
ABCa b c 2
3
DEF d e f 3
4
GH I g h i 4
5
JKL j k l 5
6
MNOm n o 6
7
PQRSpqr s 7
8
TUV t u v 8
9
WX Y Z w x y z 9
0
0!“#$%&’()
*
*+, - . / : ;<=>?
LND
Move the cursor to the left
OPAC
Move the cursor to the right
CONF
Clear the character entry to the left, one character at a time (Backspace Key)
CLEAR
Clear all the entries from the point of the flashing cursor and to the right.
FLASH
Switch the cursor moves to the upper row of the display and pressing FLASH again to moves the cursor
back to the lower row.