197
Programming Manual
Program 22: Incoming Call Setup
22-07: DIL Assignmen
SA
SB
IN
Description
Use Program 22-07 : DIL Assignment to assign the destination extension or Department Calling Group for each
DIL Incoming trunk. A DIL rings an extension directly, without any other Access Map or Ring Group programming.
If an extension has a line key, the DIL rings the line key. If the extension does not have a line key, the DIL rings
loop keys (if programmed) or the CALL key (CALL key will always ring). Use Program 22-02 to designate a trunk
as a DIL). You can make eight DIL assignments, one for each Night Service mode:
Input Data
Trunk Port Number
1-51
Day/Night
Mode
Number of Transferring Destination Default Related Program
1-8
• Extension number (Max. 4 digits)
• Department Group number
(Max.4 digits)
No setting 22-02
Conditions
Program 22-02 must be set to ‘4’ for the trunk.
Feature Cross Reference
Direct Inward Line (DIL)
Telephone Programming Instructions
To enter data for Program 22-07(DIL Assignment):
1. Enter the programming mode.
2. Enter 22 07
3. Enter the number of the item you want to program.
4. Select the Trunk number to be programmed by pressing the FLASH or the VOLUME or
VOLUME keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
22-07-01 Trunk1
Mode1 No =
22-07-xx Trunkxx
xxxxx
To Next Page
Loading...
