NEC Aspila Topaz - 33-02: Analogue Interface Group Assignment

280
Programming Manual
Program 33: Analogue Interface Ports Setup
33-02: Analogue Interface Group Assignment
IN
SA
SB
Description
Use Program 33-02 : Analogue Interface Group Assignment to assign Analogue Interface Ports (1-6) to
Department Groups. There are 4 ACI Department Groups. An ACI port can only be in one group.
Also use this program to set the ACI port’s priority. When a call comes into the ACI Department Group, it connects
to the ACI port in order of their priority. A higher priority port (e.g., 1) receives calls before a lower priority port
(e.g., 6).
Input Data
Analogue Interface Port Number Group Number
Priority
Default
1-6
1-4 1-6 See “Default”
Default
Analogue Interface Port Group Number Priority Order
111
212
:::
616
Conditions
None
Feature Cross Reference
 Analogue Interface Port
Telephone Programming Instructions
To enter data for Program 33-02 (Analogue Interface Group Assignment):
1. Enter the programming mode.
2. Enter 33 02
3. Enter the number of the item you want to program.
4. Select the Analogue Interface port number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
33-02-01ACIPort1
A
CI Group No 1
33-02-xx
A
CIPortx
xxxxx