NEC Aspila Topaz - PRG 22: Incoming Call Setup; 22-01: System Options for Incoming Calls

189
Program 22: Incoming Call Setup
22-01: System Options for Incoming Calls
Programming Manual
SA
SB
IN
Description
Use Program 22-01 : System Options for Incoming Calls to define the system options for incoming calls.
Input Data
Prog. No. Item Input data Default Description
Related
Program
22-01-01
Incoming Call
Priority
0 : Intercom Call
Priority
1 : Trunk Call
Priority
1 Use this option to determine if
Intercom calls or trunk calls have
answer priority when both are
ringing simultaneously.
22-01-02
Incoming Call
Ring No Answer
Alarm
0 : Disable
1 : Enable
0 If enabled, an incoming call that
rings longer than the Ring No
Answer Alarm interval (22-01-03),
will change to a unique ring
cadence to indicate that the call
has been ringing too long. If
disabled, this will not occur.
22-01-03
22-01-04
22-01-03
Incoming Call
Ring No Answer
Tone
0-64800(sec.) 60 If a trunk rings a key telephone
longer than this interval, the
system changes the ring cadence.
This indicates to the user that the
call has been ringing too long
22-01-02
22-01-04
DIL No Answer
Recall Time
0-64800(sec.) 0 A DIL that rings its programmed
destination longer than this
interval diverts to the DIL No
Answer Ring Group (set in
Program 22-08).
22-01-05
-Not used- - - -
22-01-06
DID Ring-No-
Answer Time
0-64800(sec.) 20 In systems with DID Ring-No-
Answer Intercept, this interval sets
the Ring-No-Answer time. This
interval is how long a DID call
rings the destination extension
before rerouting to the intercept
ring group.
22-12
22-01-07
DID Incoming
Ring Group no
answer timer
0-64800(sec.) 20
22-01-08
DID Pilot Call
No answer timer
0-64800(sec.) 60
22-01-09
DID to Trunk to
Trunk no answer
timer
0-64800(sec.) 20