NEC Aspila Topaz - Page 136

128
Programming Manual
Program 20: System Option Setup
20-02: System Options for Key telephones
IN
SA
SB
Input Data(Cont’d)
Prog. No. Item Input Data Default
20-02-09 Disconnect Supervision
Use this option to enable or disable
disconnect supervision for the system
trunks.
0 : Disable
1 : Enable
0
20-02-10 Time Before Shifting to Power-
Saving
Mode
(PRG15-02-18 should be set to “1:
Power Saving Mode”.)
0 : Power-Saving Mode Off
1 : 1 minute (Min.)
2 : 2 minutes
3 : 4 minutes
4 : 8 minutes
5 : 16 minutes
6 : 32 minutes
7 : 64 minutes
0
20-02-11 Default Setting of Microphone of Key
Telephone
0 : Off
1 : On
1
20-02-12 Forced Intercom Ringing
Use this option to enable or disable
Forced Intercom Ringing. If enabled,
incoming Intercom calls normally
ring.
If disabled, Intercom calls
voice-announce.
0 : Disable (Voice)
1 : Enable(Ring)
0
20-02-13
-Not Used-
-
20-02-14
Headset Ringing Cancel Timer 0 - 64800(sec.)
30
Conditions
None
Feature Cross Reference
 None
Telephone Programming Instructions
To enter data for Program 20-02(System Options for Key Telephones):
1. Enter the programming mode.
2. Enter 20 02
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
20-02-01
TRK Loop Key 0
20-02-xx
xxxxx