NEC Aspila Topaz - Page 143

135
Programming Manual
Program 20: System Option Setup
20-07: Class of Service Options (Administrator Level)
IN
SA
SB
Input Data(Cont’d)
Prog. No. Item Input Data Default*
Related
Program
20-07-14
VRS General Message Listen
Enables/disables extension’s ability to dial 4 or Service
Code 711 and listen to the General Message
1 11-10-21
20-07-15
VRS General Message Record
Enables/disables extension’s ability to dial Service Code
712 and record, listen to or erase the General Message
1 11-10-22
20-07-16
-Not Used-
-
20-07-17
-Not Used-
-
20-07-18 SMDR printout accumulated extension data
0 11-10-23
20-07-19 SMDR printout accumulated STG data
0 11-10-24
20-07-20 SMDR printout accumulated account code data
0 : Off
1 : On
0 11-10-25
*All Classes are above mentioned default value.
Conditions
None
Feature Cross Reference
 Class of Service
Telephone Programming Instructions
To enter data for Program 20-07(Class of Service Options(Administrator Level)):
1. Enter the programming mode.
2. Enter 20 07
3. Enter the number of the item you want to program.
4. Select the Class of Service number to be programmed by pressing the FLASH or the VOLUME or
VOLUME keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
20-07-01 F-Cls1
SW Man NT serv 0
20-07-xx F-Clsxx
xxxxx