NEC Aspila Topaz - Page 145

137
Programming Manual
Program 20: System Option Setup
20-08: Class of Service Options (Outgoing Call Service)
IN
SA
SB
Input Data(Cont’d)
Prog. No. Item Input Data Default*
Related
Program
20-08-15
Block Outgoing Caller ID
Enable (1) or disable (0) the system’s ability to
automatically block outgoing Caller ID information when
a user places a call. If this option is on, the system
automatically inserts the Caller ID block code (defined in
Program 14-01-21) before the user’s dialed digits.
0 : Off
1 : On 0
14-01-20
14-01-21
20-08-16
-Not Used-
---
20-08-17 ARS Override Access Map
0 : Disable
(Not Override)
1 : Enable
（Override)
0
*All Classes are above mentioned default value.
Conditions
None
Feature Cross Reference
 Class of Service
Telephone Programming Instructions
To enter data for Program 20-08(Class of Service Options(Outgoing Call Service)):
1. Enter the programming mode.
2. Enter 20 08
3. Enter the number of the item you want to program.
4. Select the Class of Service number to be programmed by pressing the FLASH or the VOLUME
or VOLUME keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
20-08-01 F-Cls1
Intercom Call 1
20-08-xx F-Clsxx
xxxxx