NEC Aspila Topaz - Page 151

143
Programming Manual
Program 20: System Option Setup
20-11: Class of Service Options (Hold/Transfer Service)
IN
SA
SB
Input Data(Cont’d)
Prog. No. Item Input Data Default*
Related
Program
20-11-15
VRS Personal Greeting
Enables/disables extension’s ability to dial Service Code
713 to record, listen to or erase the Personal Greeting
Message.
1
20-11-16
Call Redirect
Enable or disable a keyset user’s ability to transfer a call
to a pre-defined destination (such as an operator, voice
mail, or another extension) without answering the call.
0
20-11-17
Call transfer setup for each telephone group 1
20-11-18
No Recall
Allow (0) or prevent (1) answered Transferred calls from
recalling the originating extension.
0
20-11-19
Normal/Extended Park
Determine if an extension’s Class of Service should allow
either a normal or extended Park.
0
20-11-20 Ring Inward recall disable
0
20-11-21 On Hook Trunk to Trunk Transfer Restriction
0 : Off
1 : On
0
*All Classes are above mentioned default value.
Conditions
None
Feature Cross Reference
 Class of Service
Telephone Programming Instructions
To enter data for Program 20-11(Class of Service Options(Hold/Transfer Service)):
1. Enter the programming mode.
2. Enter 20 11
3. Enter the number of the item you want to program.
4. Select the Class of Service number to be programmed by pressing the FLASH or the VOLUME or
VOLUME keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section.
20-11-01 F-Cls1
Call Forward 1
20-11-xx F-Clsxx
xxxxx