NEC Aspila Topaz - Page 182

174
Programming Manual
Program 21: Outgoing Call Setup
21-06: Toll Restriction Table Data Setup
IN
SA
SB
Input Data(Cont’d)
Prog. No. Item Ta b le Input Data Default Description
21-06-08
PBX Access Code 1-4 Dial (Up to
2 digits)
No setting Use this option to enter the PBX
Access Code. When the system is
behind a PBX, this is the code users
dial to access a PBX trunk. Toll
Restriction begins after the PBX
access code. For PBX trunks
(Program 14-04) the system only
Toll Restricts calls that contain the
access code. Always program this
option when the system is behind a
PBX, even if you don’t want to use
Toll Restriction. PBX Access Codes
can be up to 2 digits, using 0-9, #, *
and LINE KEY 1 (don’t care). When
using Account Codes, do not use an
asterisk within a PBX access code.
Otherwise, after the *, the trunk
would stop sending digits to the
central office. Entries 1-4 correspond
to the 4 PBX Access Codes. Each
code can have up to 2 digits.
21-06-09
Specific dial
outgoing code
1-20
Dial (Up to
8 digits)
No setting
21-06-10
Outgoing Call Code
Setup
1-20
Dial (Up to
4 digits)
No setting
Conditions
None
Feature Cross Reference
 Toll Restriction